| Connection Force | Measurement made after connecting and disconnecting using standard
plug gauge 3 times. | 3-20N |
| Disconnection Force | Measurement made after connecting and disconnecting using standard
plug gauge 3 times. | 3-20N |
| Terminal Static Load | A static load of 0.1N/m (1kgf/cm) applied to the tip of the
terminal for 1 min in any direction. | No damage to the terminal such as cracks, looseness or play.
Electrical and mechanical characteristics shall be satisfied. |
| Contact Resistance | Measured at small current (100mA or less), 1000Hz. | < 30m |
| Insulation Resistance | Apply a voltage of 500V DC for 1 min to specified portions. | 100M |
| Dielectric Strength | AC 500V rms (50-60Hz) for 1 min (between body and conductor,
between conductors not to be contact, between conductors not to be
when plug is inserted). | No arcing or breakdown. |
| Solderability Test | Terminals dipped in solder bath of 2405C for 30.5 seconds. | Solder wetting time 3 sec. Soldering area > 75%. |
| Heat Test (Reflow Soldering) | Preheat: 180C for 120s. Peak Temperature: 2605C within 20s. | No deformation of case or excessive looseness of terminals.
Electrical characteristics shall be satisfied. |
| Heat Test (Soldering Iron Method) | Bit Temperature: 3305C. Application time: 30.5 sec. | No deformation of case or excessive looseness of terminals.
Electrical characteristics shall be satisfied. |
| Storage Test (Humidity & Temperature) | 402C and 90% to 96% RH for 70 hours, then maintained at standard
atmospheric conditions for 1 hour. | No damage on appearance, mechanical and electrical characteristics. |
| Storage Test (High Temperature) | 702C for 96 hours, then subjected to controlled recovery. | No damage on appearance, mechanical and electrical characteristics. |
| Storage Test (Low Temperature) | -253C for 96 hours, then subjected to controlled recovery
conditions for 1 hour. | No damage on appearance, mechanical and electrical characteristics. |
| Life Test | 5000 cycles at a speed of 10 to 20 cycles/min. | Contact resistance < 0.1. Disconnection force 3 to 20N.
Mechanical and electrical characteristics shall be satisfied. |
| Cold & Heat Shock Test | Subjected to cycles of specified conditions, then returned to room
ambient for 30 minutes. | No deformation or cracks in molded part. Insertion & Extraction
Force: 3 to 20N. Contact Resistance: Max. 30m. Insulation
Resistance: Min. 100M. Dielectric Withstanding Voltage: 500VAC/min. |
