Chamber Type UV Aging Test Machine ASR-UV200

1, lab temp: 5℃~+35℃ (Average temperature in 24 hours≤28℃)

2, humidity: ≤85%RH,

3, power supply: 220V or 380V

6, The grounding resistance of the protective ground wire is less than 4Ω;

7, The user is required to configure an air or power switch of corresponding capacity for the equipment at the installation site, and this switch must be used independently for this equipment.

8, Do not place anything within 80cm of the machine.

1, touch screen controller, accuracy ±0.1℃;

2, temp control apply P . I . D + S . S . R

3, Touch settings, digital and direct display;

4, automatic P.I.D calculation, which can reduce the inconvenience caused by manual setting;

5, Illumination and condensation can be controlled independently or in alternating cycles;

6, The independent control time of illumination and condensation and the time of alternating cycle control can be set arbitrarily within one thousand hours;

7, If an error occurs during operation or setting, a warning signal will be provided;

1, Adopt U-shaped titanium alloy high-speed heating electric heating tube;

2, Temperature control and lighting are completely independent systems;

3, The temperature control output power is calculated by a microcomputer to achieve high precision and high efficiency in power consumption;

4, The heating system has an over-temperature protection function;

5, The temperature of the black aluminum plate is controlled by an intelligent temperature controller, and the output power is calculated by a microcomputer and PID self-tuning. The monitoring adopts a standard Pt100 blackboard temperature sensor;

6, The water tank is located at the bottom of the box, with a built-in electric water heater. During the cycle test, there is a test section called dark condensation process, which requires the box to produce high-temperature saturated water vapor. When the water vapor encounters the relatively cold sample surface, it will condense on the sample surface.