GROW K219-A+R503 Programmable Fingerprint Infrared Control Board Control Relay Time Control Switch

Technical Parameters

Power supply:DC12V

Output:Relay(Max. current: 10A)

Fingerprint capacity:120 pieces(20 fingerprints per relay position)

Operation Instruction

1. SET Button:

1.1 Register Fingerprint:

2. Remote Control:

(Before operation, it is necessary to wake up the module standby. Touch the fingerprint module, and the indicator light is on, then it can be set.)

Default administrative password: 123456 Password length: 6 numbers

2.1. Password Using: Press *Password. Red indicator lighted means in programming stated, music means operation successful. Press # to exit.

Administrative password only can be used for administrative settings, not for unlocking.

2.2. Change Administrative Password: Press *Password*1*New Password*New Password#

2.3. Register User Fingerprint: Press *Password*2*Relay Position(01-06)#

The light in this location will turn on,put the finger in the collection area,fingerprint register successful when hearing music. Fingerprint can be registered continuously when system in register state. If the fingerprints is full, will have "Di Di Di" warning tone. (Note: when one finger registered in several relay positions at the same time,the finger can open different relays, and the interval time is 0.5 seconds)

2.4. Delete User Fingerprint: Press *Password*6*Relay Position(01-06)#

The light in this location will turn on and can hear music, indicating that the fingerprint of the relay position has been deleted successfully

2.5. Setting Relay Time: Press *Password*5*Relay Position(01-06)*Time(00-99)#

(00 means 0.5s, 01 means 1s, 02 means 2s,...,99 means 99s)

2.6. Clean the system and back to factory default: Press *Password*3*Password#

All relay lights are on, indicating that clearing is successful and back to factory default.