90 Degree Folding Arm Adjustable Speed Vehicle Barrier Gate Vehicle Access Control Systems

1. Technical parameters

1. Working temperature(motor): -35℃~+60℃
2. Rated voltage:DC24V
3. Running speed:1.5s-8s
4. Rated current:8.58A
5. Rated power:160W
6. No-load speed:1850rpm
7. Rated speed:1400rpm
8. Output Power:56.8N.m

2, Select and commission spring

The barrier gate is well-adjusted before delivery.For further adjustment,please follow below instructions.

The spring is stretchable one and the specification is as follows:
Diameter 4.5MM red color
Diameter 5.5MM blue color
Diameter 6.8MM yellow color
Diameter 7.0MM white color
The spring length is subject to the actual product. Design changes will be notified separately.

3. Features

1). Auto-delay when closing(adjustable)

2). Run speed can adjust from 2.5sec to 8sec

3). Arm automaticlly locking when power off, then open the barrier gate by motor wheel

4). Remote control to operate the barrier gate.

5). Auto-reverse when the boom meets obstruction.

6). Infrared photocells connector is available.

7). Loop detector connector is available.

8). Well-intergrated with car parking system equipment,with wire control(must be switch signal).

9). Connector for traffic light(AC220V,power less than 40W)

10). Offering dry contact signal for car parking system(COM,NC,NO)

4. Adjust the Position of Barrier Arm

To adjust the position of the arm (for example, after exerting excessive force), please take the steps as below:
open the barrier gate door and remove the cover
Loosen the two fastening screws of the DZ-8 on the pendulum shaft with an M12 Allen key, so that the barrier

arm can be repositioned by hand.
Calibrate the position of the barrier arm (horizontal position, as shown in Figure 1).
Use a hexagon wrench to re-tighten the two fastening screws

Function setting description
When setting the function, please press the menu button on the control panel. The Nixie tube displays H00-00 or

H00-other numbers. We correspond to the function parameter table code to enter the required function parameter

setting. For example, H00-00 is the UP ARM speed adjustment, and then press the confirm button Enter the parameter

setting, the number will be displayed on the digital tube, then press the up or down key to set the required UP ARM speed

number, and then press the confirm button to complete the ARM-up speed setting.