VS3202 | DeltaV | SLS 1508 Redundant Logic Solver – includes
Terminal Block
- Product Type : DeltaV SLS 1508 Redundant Logic Solver – includes
Terminal Block
- Power – 2 A @ 24 V DC + Dig out Field Loads
- Input Power : 24 V DC ± 20%, 1.0 A plus field power (5.0 A total)
- Field Power : 4 A maximum (actual value depends upon channel type
and field device type)
- Shipping weight : 2.5 Kg
| Input power | 15-20 Watts per fan |
| Line Amps | 0.24-0.34 Amps per fan |
| Operating temperature | -28 to 70 degrees Celsius |
| Weight | 4 pounds |
| Filter | Polyurethane Foam, 30 PPI |
| Retainer | UL94V-0 Plastic |
| Compatibility | 5-slot series 90-70 racks and the 9-slots RX7i racks |
DeltaV SIS Product Data Sheet
Product Description This section provides general information on
DeltaV SIS hardware. Refer to the Installing Your DeltaV Digital
Automation System manual for more information on DeltaV system
equipment. DeltaV SIS Equipment A DeltaV automation system consists
of carriers, one or more I/O subsystems, controllers, power
supplies, workstations, and a control network. The DeltaV SIS
system consists of: Redundant Logic Solvers (SLS 1508) and
termination blocks SISnet Repeaters (see separate product data
sheet) Carrier extender cables Local peer bus extender cables
Right 1-wide carrier with termination
System Compatibility DeltaV SLS 1508 Specifications Common
Environmental Specifications for SLS 1508 Logic Solver Category
Specifications: Storage temperature -40 to 85 C (-40 to 185 F)
Operating temperature -40 to 70 C (-40 to 158 F) Relative
humidity 5 to 95% , non-condensing Airborne contaminants
ISA-S71.04-1985 Airborne Contaminants Class G3 Conformal coating
Protection rating IP 20, NEMA 12 Hazardous area/location European
EMC Directive per EN61326-1, Criterion A NAMUR NE21 EMC
Requirements Low Voltage Directive IEC 61010-1 Factory Mutual,
Non-Arcing Class 1, Div 2, Groups A, B, C, D, T4 hazardous
locations ATEX 3 G EEx IIC-nA T4 EN50021:1999 CSA 1010 Shock 10 g
½-sine wave for 11 ms Vibration 1 mm peak-to-peak from 5 to 16 Hz;
0.5 g from 16 to 150 Hz SLS 1508 Logic Solver Physical
Specifications Item Specifications: Input Power 24 V DC 20%, 1.0
A plus field power (5.0 A total) Note: It is recommended that the
SLS and DeltaV controller and I/O use separate power supplies Field
Power 4 A maximum (actual value depends upon channel type and field
device type) Isolation Each channel is optically isolated from the
system and factory-tested to 1500 V DC. No channel-tochannel
isolation. Local Bus current None Mounting In SIS (yellow) terminal
blocks in odd-numbered slots (1, 3, 5, 7) on the 8-wide carrier.
Redundant SLSs take 4 slots.
Overview
Logic Solvers (SLS1508) contain the logic-solving capability and provide an
interface to 16 I/O channels that can be configured as Discrete
Input, Discrete Output, Analog Input (HART) and HART two-state
output channels. Logic Solvers and termination blocks install on
the 8-wide carrier. Logic Solvers communicate with each other
through the carriers over a two-channel, local peer bus (SISnet)
and remote peer ring. Local Logic Solvers are hosted by the same
DeltaV controller and remote Logic Solvers are hosted by a
different DeltaV controller. Logic Solvers are powered by a 24 V DC
power supply that is separate from the power supply that drives the
DeltaV controller and I/O. Logic Solvers install in odd-numbered
slots (1,3,5,7) on the 8-wide carrier. Redundant Logic Solvers use
four slots.
Our advantage Products:
【Honeywell】Module DCS / PLC
【Emerson】DeltaV Module / Servo Motor
【ABB】Input Output Module
【AB】Module / Touch Screen
【Rosemount】Pressure and Temperature Transmitter
【Yokogawa】Pressure Transmitter
【Yaskawa】Servo Drive / Servo Motor
【Mitsubishi】Servo Drive / Servo Motor
【GE】IC69 Series PLC/ Fanuc Servo Motor and Drive
(Modicon,SMC,SICK,NORGREN,Siemens etc.)
1746-NR4 AB Analog Input Module 500 Volts/1 minute SLC 500 RTD/Resistance
